COVERAGE:
12m² to 14m² per litre depending on the porosity and the texture of the surface.

SURFACE PREPARATION:
All surfaces should be thoroughly cleaned and free of scale , dust , dirt and grease. If oil or grease is evident wash with a suitable detergent and water solution to remove any contaminants. Pre-painted surfaces should be scraped free of all loose and flaking paint and abraded with sand-paper prior to application. Timber Deck & Render can be used without a primer , but for optimum results – it is recommended to prime the surface with Colormaker Pink Wood Primer . On new galvanized iron degrease by washing with mineral turpentine and prime with Colormaker Galvanised Iron Primer before application.

STIRRING:
Mix contents thoroughly prior to application. Use broad flat stirrer with a circular motion for best results.

THINNING:
 Not normally necessary. If required thin sparingly with water.

PRIMING:
 Not normally necessary. On new wood and metal optimum results can be achieved using an appropriate primer.

APPLICATION:
Brush – Apply liberally and lay off with tip of brush.
Roller – Use a medium (12mm ) nap for best results.
Spray – 11 thou. tip , thin sparingly with water if required . Apply evenly covering smaller areas at a time. Do not apply if the temperature falls below 10°C or rises above 35°C. Generally two coats will be required for most surfaces. Avoid application in direct sunlight. Timber Deck & Render is not suitable for areas subject to motor vehicle traffic – products designed specifically for this application are available from Colormaker Industries.

NON-SLIP FINISH:
A non-slip surface can be created easily with the addition of Colormaker Non-Slip Additive. Add Non-Slip Additive to Timber Deck & Render at the rate of 60-75 grams per litre while stirring with a flat blade stirrer and allow to stand for 10 minutes before applying.

TOUCH-DRY:
Under normal drying conditions Timber Deck & Render is touch-dry in approximately 20 minutes.

RE-COAT:
Under normal drying conditions Timber Deck & Render can be re-coated after 2 hours drying and can be walked on after overnight drying.

CLEAN-UP:
Clean all painting equipment ( while wet ) with water- the addition of detergent may aid cleaning.

SAFETY:
KEEP OUT OF REACH OF CHILDREN.
PROVIDE ADEQUATE VENTILATION DURING USE.